Electrosolv-E must only be used in sufficiently ventilated
areas.
Electrosolv-E should always be used undiluted. It can be applied by brush, swab, or as a fine spray using suitable hand held spray equipment.
NOTE: Never open flame when using fine spray.
Small components may be cleaned by brief immersion in a bath of Electrosolv-E.
The most suitable way of applying Electrosolv-E is by using hand spray or syphon spray guns. Once the deposits of dirt and grease have been flushed away with Electrosolv-E the remaining solvent may be evaporated by using clean compressed air at low pressure and high volume.
Caution: Never use Electrosolv-E on a running generator or motor.
Electrosolv-E can be used to clean virtually all electrical equipment and components although it may affect some types of rubber and plastic. Either remove rubber and plastic parts from component or test on small area for any reaction before cleaning. After cleaning motors or generators insulation resistance to ground should be tested to check that it is within its specified limits. Sprayers: a range of spray equipment is available for use with Electrosolv-E and other solvents.